--- /dev/null
+# Copyright (C) 2017 Nippon Telegraph and Telephone Corporation.
+#
+# Licensed under the Apache License, Version 2.0 (the "License");
+# you may not use this file except in compliance with the License.
+# You may obtain a copy of the License at
+#
+# http://www.apache.org/licenses/LICENSE-2.0
+#
+# Unless required by applicable law or agreed to in writing, software
+# distributed under the License is distributed on an "AS IS" BASIS,
+# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or
+# implied.
+# See the License for the specific language governing permissions and
+# limitations under the License.
+
+# Constants defined in netdevice(7)
+
+# Interface flags
+# from net/if.h
+IFF_UP = 1 << 0 # Interface is running.
+IFF_BROADCAST = 1 << 1 # Valid broadcast address set.
+IFF_DEBUG = 1 << 2 # Internal debugging flag.
+IFF_LOOPBACK = 1 << 3 # Interface is a loopback interface.
+IFF_POINTOPOINT = 1 << 4 # Interface is a point-to-point link.
+IFF_NOTRAILERS = 1 << 5 # Avoid use of trailers.
+IFF_RUNNING = 1 << 6 # Resources allocated.
+IFF_NOARP = 1 << 7 # No arp protocol, L2 destination address not set.
+IFF_PROMISC = 1 << 8 # Interface is in promiscuous mode.
+IFF_ALLMULTI = 1 << 9 # Receive all multicast packets.
+IFF_MASTER = 1 << 10 # Master of a load balancing bundle.
+IFF_SLAVE = 1 << 11 # Slave of a load balancing bundle.
+IFF_MULTICAST = 1 << 12 # Supports multicast.
+IFF_PORTSEL = 1 << 13 # Is able to select media type via ifmap.
+IFF_AUTOMEDIA = 1 << 14 # Auto media selection active.
+IFF_DYNAMIC = 1 << 15 # The addresses are lost when the interface goes down.
+# from linux/if.h
+IFF_LOWER_UP = 1 << 16 # Driver signals L1 up. (since Linux 2.6.17)
+IFF_DORMANT = 1 << 17 # Driver signals dormant. (since Linux 2.6.17)
+IFF_ECHO = 1 << 18 # Echo sent packets. (since Linux 2.6.25)
+
+# Private interface flags
+# from linux/netdevice.h
+IFF_802_1Q_VLAN = 1 << 0 # 802.1Q VLAN device.
+IFF_EBRIDGE = 1 << 1 # Ethernet bridging device.
+IFF_BONDING = 1 << 2 # bonding master or slave.
+IFF_ISATAP = 1 << 3 # ISATAP interface (RFC4214).
+IFF_WAN_HDLC = 1 << 4 # WAN HDLC device.
+IFF_XMIT_DST_RELEASE = 1 << 5 # dev_hard_start_xmit() is allowed to release skb->dst.
+IFF_DONT_BRIDGE = 1 << 6 # disallow bridging this ether dev.
+IFF_DISABLE_NETPOLL = 1 << 7 # disable netpoll at run-time.
+IFF_MACVLAN_PORT = 1 << 8 # device used as macvlan port.
+IFF_BRIDGE_PORT = 1 << 9 # device used as bridge port.
+IFF_OVS_DATAPATH = 1 << 10 # device used as Open vSwitch datapath port.
+IFF_TX_SKB_SHARING = 1 << 11 # The interface supports sharing skbs on transmit.
+IFF_UNICAST_FLT = 1 << 12 # Supports unicast filtering.
+IFF_TEAM_PORT = 1 << 13 # device used as team port.
+IFF_SUPP_NOFCS = 1 << 14 # device supports sending custom FCS.
+IFF_LIVE_ADDR_CHANGE = 1 << 15 # device supports hardware address change when it's running.
+IFF_MACVLAN = 1 << 16 # Macvlan device.
+IFF_XMIT_DST_RELEASE_PERM = 1 << 17 # IFF_XMIT_DST_RELEASE not taking into account underlying stacked devices.
+IFF_IPVLAN_MASTER = 1 << 18 # IPvlan master device.
+IFF_IPVLAN_SLAVE = 1 << 19 # IPvlan slave device.
+IFF_L3MDEV_MASTER = 1 << 20 # device is an L3 master device.
+IFF_NO_QUEUE = 1 << 21 # device can run without qdisc attached.
+IFF_OPENVSWITCH = 1 << 22 # device is a Open vSwitch master.
+IFF_L3MDEV_SLAVE = 1 << 23 # device is enslaved to an L3 master device.
+IFF_TEAM = 1 << 24 # device is a team device.
+IFF_RXFH_CONFIGURED = 1 << 25 # device has had Rx Flow indirection table configured.
+IFF_PHONY_HEADROOM = 1 << 26 # the headroom value is controlled by an external entity. (i.e. the master device for bridged veth)
+IFF_MACSEC = 1 << 27 # device is a MACsec device.
projects / vsorcdistro / .git / blobdiff